I’m using Ladybug/Honeybee in Rhino to map UTCI at 2 pm for a January semifinal in Melbourne and pairing it with OpenFOAM (Butterfly) to study cross-court winds. Is there a cleaner way to keep C-values >= 90 mm while sizing a PV canopy that drops mean radiant temperature — ideally with LCA feedback (Tally or One Click LCA) inside the same parametric loop?
But > radiant temperature — ideally with LCA feedback (Tally or One Click LCA) inside the same parametric Same here — my cleanest setup was a GH loop where a custom C‑value script checks each row against 90 mm while Honeybee runs UTCI, and I stream canopy material takeoffs straight from Grasshopper to One Click LCA via Speckle so LCA stays in-loop; Tally’s doable but tends to break the loop via Revit — are you okay using Speckle?